WCDMA RAN Systems and Site Introduction. RBS components. WCDMA RBS Maintenance. 2. Customer Product Information (CPI) and. TXO Systems has the ERICSSON RBS RRUS 12 B3 in stock, along with a wide range of used and refurbished telecommunications equipment from all. Ericsson shall have no liability for any error or damage of any kind resulting from The support system for the RBS main unit is available in two variants.
|Published (Last):||26 March 2010|
|PDF File Size:||7.62 Mb|
|ePub File Size:||16.8 Mb|
|Price:||Free* [*Free Regsitration Required]|
Our quick turnaround times mean that we can ship same-day replacements, minimising network downtime. To power up the RBS: Always sricsson products to ground according to instructions. Clean the site and remove objects such as wrapping paper and cable clippings.
Ericsson RBS LTE Indoor Main Unit Remote Base Station 1/bfl /4 | eBay
External transmission cables ericdson be connected to the TCU if applicable. Screws required to install the main unit in the rack are not included. If the node configuration is a dual support system configuration, each support system requires a separate DC in cable and fuse.
The positions indicated in the figures can vary. Never look directly into the end of an optical cable, or other laser source.
The fans in both support systems are controlled by the primary DU. Log In Sign Up.
ericsson rbs 6601
Remove the protective cap from the active fiber marked with white. Fill in the verification checklist in Site Installation Documentation. Place the main unit in the rack. Remove the protective caps from the connectors on the cables and the XMU. If caps are missing or if the connectors are dirty, use rbbs end-face cleaner. Make sure that the site power is switched off before starting.
BTS FOR ERICSSON RBS – BFL /1 R3A – DUW 20 01 – KDU /2 R3B | eBay
Detailed information about optical indicators can be found in Indicators, Buttons, and Switches. Unpack the TCU and verify that it is not damaged. To connect the optical cables to the DU: Follow steps 1 and 2 as described in Section For instructions on how to connect the optical cable to a bidirectional transceiver SFP, see Section The minimum bending cables for other cables can be found in the manufacturer’s specification.
See eicsson the following documents for verifying ericdson units installation: Sell now – Have one to sell?
Add to cart – Best Offer: Watch list is full. Refer to eBay Return policy rs more details. Install the railings on the main unit and tighten the M4 screws in the brackets to a torque of 1.
To install a TCU in slot 2 in the main unit: Therefore, a minimum free space of 50 mm in front of, and 50 mm behind the main unit is required.
Insert the power cable wires into each dedicated tension clamp connection and check that they are properly fastened. If any red optical indicator is on or if any other optical indicator does not lit as it should, then dricsson the next level of maintenance support. Insert the TCU in slot 2 in the main unit.
Ericsson RBS 6601 LTE Indoor Main Unit Remote Base Station 1/bfl 901 009/4
See other items More Seller assumes all responsibility for this ericsxon. This document describes how to install the RBS on site and how to connect it to external interfaces.
Rhs the fans are inaccessible from the back of the rack, the replacement of the fans requires that the main unit is removed from the rack.